![]() The content provided is as is and without express or implied warranties of any kind. The PERC S100 adapter solution supports SATA Hard Disk Drives (HDD) and Solid State Disk (SSD) drives. Dell reserves the right to make changes without further notice to any products herein. The PERC S100 adaper is targeted as a low-cost RAID solution for Dell PowerEdge Value Servers. So you can use your SATA drives and build the RAID.This document is for informational purposes only. Option 3: There are also hardware RAID cards that do IDE, SATA, eSATA drives, etc. ![]() This means more expense since I had 2 SATA drives and meant getting SAS drives to match the SAS RAID controller cards. When the controller displays 'Press to run the Option ROM Configuration For Arrays Utility,' press F8. In 16-bay systems there is usually a P410 along with a P410i controller. Option 2: Use add-on hardware RAID card to server such as PERC 6/E SAS controller with RAID or SAS 6I/R SAS controller with RAID. The Option ROM messages will go through each RAID controller installed on the system. I am assuming the H200 is hardware raid but does pfSense support it Thanks. For example, a RAID 10 virtual disk cannot be. For the drive controller would you recommend PERC S100, S300 or the H200 We want to run Raid 1 and I see on Dells site that they say S100 / S300 are only supported in Windows. The PERC S130 controller does not allow: Creating a virtual disk from a mix of different type physical disks. see here for CentOS 5 guide.Īnd if the software RAID breaks, here’s the guide to fix it. I will make the adjustment to XEON and Intel Nics as suggested. You can now use standard software RAID provided by Linux. Option 1: Disable RAID storage – the S100/S300 controllers by visiting BIOS settings. You cannot use the Dell PowerEdge S100 and S300 PERC RAID controllers under Linux and they are software only RAID (fake RAID device) and it only works with MS-Windows operating systems. How do I use the Dell PowerEdge S100 and S300 Software RAID controllers with Linux operating systems? This was due to code not being released to the public so linux drivers can be written for it or something like that. I rang Dell and they let me know this fact. Installing CentOS, it still saw the 2 physical drives instead of just 1 drive in a RAID 1 array. Booting it said it had 2 SATA 250GB drives in a RAID1 setup. ![]() ![]() I found this out after buying the Dell T110 server. I didn’t know that Dell’s PERC S100/S300 RAID only worked for windows.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |